This Release Note describes the Industry Canada Approval for RealFLO version 6.10. The flow computers and hardware listed in this release note have been submitted to Industry Canada for testing and received the approvals listed.

Industry Canada Approvals

The following Industry Canada approval numbers are for the 4202GFC and the 4102MMT:

• Approval number AG-0536C for 4202GFC
• Approval number AG-0533 for 4102MMT
• Existing Industry Canada approval number AG-0483 for SCADAPack, SCADAPack Light, SCADAPack Plus, SCADAPack LP and Micro16 controllers, has been revised to AG-0483 Rev.1. AG-0483 Rev. 1 is a Modification of Approval that updates the previous approval for using RealFLO 6.10.

Note that RealFLO 3.00 and Flow Computer 3.00 are still IC approved for custody transfer installations. See AG-0483 for details. These versions are not recommended for new installations.
These approvals are posted on the Industry Canada web site at http://strategis.ic.gc.ca.

Software and Hardware Relevant to this Release

Flow Computer version 6.10 build 6 must be loaded into the controller and the Industry Canada lockout jumper for the controller must be installed.

• The SCADAPack/ SCADAPack Light/SCADAPack Plus/ SCADAPack LP / Micro16 lockout cable is installed on the I2C bus connector P1 or P2.
• The 4202GFC flow computers lockout jumper is installed between COM and CTR0/DIN. A lockout screw and sealing wire is included with the Industry Canada Approved version of the 4202GFC. The transmitter band includes the Industry Canada approval number AG-0536C.

Firmware Version Requirements

The following table shows the firmware version that is approved for use with Industry Canada Approved flow computers. The indicated firmware version must be loaded into approved flow computers.