General Information

This note describes the changes included in TelePACE 5.0.5 released on September 11, 2012.

Changes Made

  • TelePACE Studio version 5.0.4 (build 1676) replaced with version 5.0.5 (build 1688).
  • TelePACE Studio Evaluation version 5.0.5 (build 1676) replaced with version 5.0.4 (build 1688).

Improvements Made in 5.0.5

  • Search results are identified as 'May no longer be accurate' after changes are made to the logic.
  • Include .NET 3.5 on Telepace Studio CD
  • Update setup to include latest firmware

Issues Corrected in 5.0.5

  • Corrections to the Search functionality
  • Monitor Element dialog is too small
  • Multiple coil search returns contacts and coils, rather than just coils.

Upgrade Procedures

  • You can obtain a copy of TelePACE Studio 5.0.5 by contacting Control Microsystems Sales Support (salessupport@controlmicrosystems.com)
  • Run Setup.exe to install TelePACE Studio. You do not need to uninstall, the installer will replace any earlier version of TelePACE Studio.