This note describes the changes included in SCADAPack E-Series Firmware 7.82 released on March 14, 2011.

Software and Hardware Relevant to this Release

This is a production release for SCADAPack 300E Series, ES and ER, and Serck 386 eNET, Serck 586 eNET and Serck Magna eNET controllers.

Firmware for SCADAPack 314E, 330E, 334E, 350E and 357E:

• SCADAPack 300E main firmware 7.75 build 1074 is replaced with 7.82 build 1100.
• SCADAPack 300E OS Loader 2.11 is unchanged.

Firmware for SCADAPack ES:

• SCADAPack ES main firmware 7.75 build 1074 is replaced with 7.82 build 1100.
• SCADAPack ES I/O board firmware x.07 in unchanged.
• SCADAPack ES Controller I/O PIC firmware 3.00 build 3 is unchanged.
• SCADAPack ES Boot Monitor version 2.15 is unchanged.

Firmware for SCADAPack ER:

• SCADAPack ER main firmware 7.75 build 1074 is replaced with 7.82 build 1100.
• SCADAPack ER I/O module firmware:
  • SME/ER-4AO-A firmware v002 is unchanged
  • SME/ER-16AI-A firmware v007 in unchanged
  • SME/ER-16RO-A firmware v009 is unchanged
  • SME/ER-32DI-A firmware v008 is unchanged
  • SME-32DI-B firmware v001 is unchanged.
• SCADAPack ER 386 firmware version 1.04 is unchanged.
• SCADAPack ER Boot Monitor version 2.16 is unchanged.

These changes apply to Serck Controls 386 eNET controllers:

• 386 eNET main firmware 7.75 build 1074 is replaced with firmware 7.82 build 1100
• 386 eNET boot monitor version 2.15 is unchanged

New Features Introduced in Firmware Version 7.82

• SLIP and CSLIP support (not supported on legacy 386 eNET)
• Integrating Analogue Deadbands Algorithm (not supported on legacy 386 eNET)

Improvements Made in Firmware Version 7.82

• Long ISaGRAF cycle times caused by Tune Alarm Limits by INC file
• Ignore IIN flags from remote in DCON Configuration

Corrections made to Firmware Version 7.82

• RTU crashes when debugging E-Series ISaGRAF via E-Series Configurator connection
• RTU CROB Commands Fail after Power Cycle
• Unexpected database interaction between system points (Hardware Type reported incorrectly)
• Remote I/O system points not recreated following firmware upgrade
• Controller Reset with Reason 0x402 due to insufficient ISaGRAF stack space
• Data Concentrator CPU reset
• Remote IO counters fail after a restart
• Using DF1 Output Board causes SP334E controller exception
• IEC60870-5-101 Slave freezing, all tasks on controller run slow.